Dell D1626HT - UltraScan 1600HS - 21" CRT Display 서비스 매뉴얼 - 페이지 9

{카테고리_이름} Dell D1626HT - UltraScan 1600HS - 21" CRT Display에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell D1626HT - UltraScan 1600HS - 21" CRT Display 48 페이지. Color monitor
Dell D1626HT - UltraScan 1600HS - 21" CRT Display에 대해서도 마찬가지입니다: 서비스 매뉴얼 (48 페이지)

페이지 인쇄

4 Using the ZOOM OSD

You can enlarge or reduce the picture size using the ZOOM

OSD.

This setting is stored in memory for the current input signal.

1 Press the MENU button to display the MENU OSD.

2 Highlight the ZOOM OSD using the BRIGHTNESS and

CONTRAST buttons and press the MENU button again.

3 Press the > (CONTRAST) ? // buttons to enlarge or

reduce the picture size.

4 Press the MENU button once to return to the MENU OSD,

or press it twice to return to normal viewing.

Note

You can enlarge or reduce the picture size until either the

horizontal or vertical size reaches its maximum or minimum

value.

All manuals and user guides at all-guides.com

5 Using the OPTION OSD

You can manually degauss (demagnetize) the CRT, select the

input signal, move the OSD position, set the Power Saving

delay time, and lock the user controls using the OPTION OSD.

1 Press the MENU button to display the MENU OSD.

2 Highlight the OPTION OSD using the BRIGHTNESS and

3 Press the ¨ (BRIGHTNESS) ./> buttons to select the

4 Press the > (CONTRAST) ? // buttons to activate the

5 Press the MENU button once to return to the MENU OSD,

Degauss: If a second degauss cycle is needed, allow a minimum

interval of 20 minutes for the best result.

Input Signal Selection: Select the desired input signal when

two computers are connected.

OSD Position Change: To change the OSD position, press the

¨ (BRIGHTNESS) ./> buttons to select the direction

(horizontal or vertical), then press the > (CONTRAST)

?// buttons to move the OSD in the selected direction.

Power Saving Delay Time: The monitor enters Power Saving

mode after the selected time elapses. If you select "OFF," the

monitor does not go into Power Saving mode.

User Control Lock: Once you select "ON" to lock the user

controls, you cannot select any item except "EXIT" and

"OPTION" in the MENU OSD. If you try to access any other

OSD, the H mark appears on the screen.

To cancel the Control Lock: Repeat the above procedure and

set Control Lock to "OFF."

Customizing Your Monitor

Getting Started

CONTRAST buttons and press the MENU button again.

desired adjustment item.

manual degauss, select the input signal, move the OSD

position, change the Power Saving delay time or lock the

user controls.

or press it twice to return to normal viewing.

C s