Allied Telesis Rapier 16fi 빠른 설치 매뉴얼 - 페이지 9

{카테고리_이름} Allied Telesis Rapier 16fi에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis Rapier 16fi 12 페이지. Rapier switch
Allied Telesis Rapier 16fi에 대해서도 마찬가지입니다: 데이터시트 (6 페이지), 데이터시트 (3 페이지), 데이터시트 (2 페이지), 브로셔 (8 페이지), 빠른 설치 매뉴얼 (13 페이지)

페이지 인쇄
Allied Telesis Rapier 16fi 빠른 설치 매뉴얼
Quick Install Guide
Rapier
C613-04017-01 REV H
See the Rapier Switch Software Reference for more information on start-up
and configuration procedures (including a list of message definitions).
Using the GUI to configure a switch
This section describes how to access the GUI from a PC via VLAN1, in
order to configure the switch. It assumes that the PC and the switch are in
the same subnet. By default, all switch ports are members of VLAN1.
The GUI requires a PC and web browser. Supported browsers are Internet
Explorer 5.0 and greater, or Netscape 6.2.2 or 6.2.3, with JavaScript enabled.
If you are using a toolbar or plug-in on your browser to block pop-ups,
disable it while using the GUI. The GUI displays detailed configuration
options and information in pop-up windows.
1.
Connect the PC to a switch port.
The PC can be connected directly, or through your LAN.
To connect the PC directly to the switch, use a straight-through Ethernet
cable to connect an Ethernet card on the PC to any one of the switch ports.
Note the PC's IP address and mask.
Rapier
To connect via a LAN, use an Ethernet cable to connect the switch port(s) to
the device(s) on the LAN. Select the LAN PC from which you wish to
configure the switch. The PC should be in the same subnet as the part of
the LAN that contains the switch (for example, the PC could be connected
to a hub or Layer 2 switch that is directly connected to one of the switch's
ports). Note the PC's IP address and mask.
switch ports
2.
Access the CLI on the switch.
Follow the instructions in the previous "Using the CLI to configure a
switch" section.
3.
Enable IP.
At the CLI, enter the command:
ENABLE IP
4.
Assign an IP address to VLAN1.
Assign the VLAN1 interface an IP address in the subnet that the PC uses,
using the command:
ADD IP INTERFACE=vlan1 IP=ipaddress MASK=mask
switch ports
hub or layer 2 switch
9
PC
PC