Allied Telesis x900-48 series 기능 설명서

{카테고리_이름} Allied Telesis x900-48 series에 대한 기능 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis x900-48 series 18 페이지. Configuring hardware filters
Allied Telesis x900-48 series에 대해서도 마찬가지입니다: 데이터시트 (5 페이지)

페이지 인쇄

AlliedWare

Configure Hardware Filters on AT-9900, x900-48,

How To |

and x900-24 Series Switches

Introduction

The AT-9900, x900-48, and x900-24 series switches support a powerful hardware based

packet-filtering facility.

These switches can filter on a range of Layer 2, Layer 3, and Layer 4 packet attributes, and

perform a variety of different actions on the packets that match the filters.

Because the filters are hardware-based, they put no load on the CPU of the switch, and have

no affect on the throughput of the switch. It is possible to configure over 1000 different

filters, and still have complete wire speed throughput on the switch.

The following configuration methods are available:

To filter traffic across all ports on the switch, create dedicated hardware filters.

To filter traffic on a per-port basis, apply filtering actions to QoS flow groups or traffic

classes.

This Note only describes method 1. Method 2 is described in How To Configure Filtering Actions

on QoS Flow Groups and Traffic Classes, available from

literature/howto.aspx.

C613-16058-00 REV C