Dell UltraSharp U2412MWh 사용자 설명서 - 페이지 21

{카테고리_이름} Dell UltraSharp U2412MWh에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell UltraSharp U2412MWh 49 페이지.
Dell UltraSharp U2412MWh에 대해서도 마찬가지입니다: 사용자 설명서 (48 페이지)

페이지 인쇄

Back to Contents Page

Setting Up the Monitor

Dell™ UltraSharp U2412M/U2412MWh Monitor User's Guide

Attaching the Stand

Connecting the Monitor

Organizing Your Cables

Attaching the Soundbar AX510/AX510PA (optional)

Removing the Stand

Wall Mounting (Optional)

Attaching the Stand

NOTE:

The stand is detached when the monitor is shipped from the factory.

This is applicable for a monitor with a stand. When any other stand is bought, please refer to the respective stand setup guide for set up

NOTE:

instructions.

To attach the monitor stand:

1. Remove the cover and place the monitor on it.

2. Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.

3. Press the stand till it snaps into its place.

Connecting Your Monitor

WARNING:

Before you begin any of the procedures in this section, follow the

To connect your monitor to the computer:

1. Turn off your computer and disconnect the power cable.

Connect the blue (VGA) cable from your monitor to your computer.

NOTE:

If your computer supports a white DVI connector, connect the white DVI cable to the monitor and the white DVI connector on

your computer.

NOTE:

Do not connect the blue VGA, the white DVI, or the black DisplayPort cables to the computer at the same time.

2. Connect the white (digital DVI-D) or the blue (analog VGA) or the black (DisplayPort) display connector cable to the corresponding video port on the back of your

computer. Do not use the three cables on the same computer. Use all cables only when they are connected to three different computers with appropriate video

systems.

Safety

Instructions.