Dell CONAE 소유자 매뉴얼 - 페이지 22

{카테고리_이름} Dell CONAE에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell CONAE 36 페이지. Direct-attach storage for poweredge serve

SAS Drives

To replace a drive, remove the drive carrier from the expansion enclosure and replace the drive in the carrier.

Drives are hot-swappable, which means they can be replaced without powering off the enclosure. Failed disk drives must be

replaced with approved disk drives. See the MD24 Series System Support Matrix for supported disk drives.

NOTE:

● The MD2412 enclosures do not support SATA, SSD, NVMe, vSAS, or 2.5 in. drives.

● The MD2424 enclosures do not support SATA, NVMe, or vSAS drives.

● Follow the safety guidelines listed in the Safety precautions.

● Follow all guidelines listed in the ESD precautions.

If you insert a SATA drive into the enclosure and then replace it with a SAS drive, the enclosure will not recognize the SAS drive.

See

Troubleshooting drives

Removing a drive blank

Prerequisites

● Follow the safety guidelines listed in the

● If installed,

Remove the front

About this task

CAUTION:

To maintain proper system cooling, drive blanks must be installed in all empty drive slots. If you

replace a drive blank with a drive, store the drive blank for future use.

Steps

Press the release button and slide the drive blank out of the drive slot.

Figure 17. Removing a drive blank

Installing a drive blank

Prerequisites

● Follow the safety guidelines listed in the

● If installed,

Remove the front

Steps

Insert the drive blank into the drive slot until the release button clicks into place.

Replacing components

for information about how to recover from this state.

Safety

precautions.

bezel.

Safety

precautions.

bezel.