Dell DX6012S 설정 및 구성 매뉴얼 - 페이지 9

{카테고리_이름} Dell DX6012S에 대한 설정 및 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell DX6012S 43 페이지. Rack installation instructions — static rails
Dell DX6012S에 대해서도 마찬가지입니다: 보충 설명서 (4 페이지), 하드웨어 설치 지침 (2 페이지), 사용자 설명서 (46 페이지), 설치 및 구성 매뉴얼 (35 페이지), 시작하기 매뉴얼 (28 페이지), 공지 사항 (28 페이지), 공지 사항 (20 페이지), 개요 (19 페이지), 구성 매뉴얼 (9 페이지), 구성 매뉴얼 (9 페이지), 릴리스 노트 (8 페이지), 구성 매뉴얼 (7 페이지), 릴리스 노트 (6 페이지), 릴리스 노트 (5 페이지), 릴리스 정보 (5 페이지), 시작하기 매뉴얼 (47 페이지), 설치 (2 페이지), 랙 설치 (2 페이지)

3.1.1. Structure of a DX Content Router Node

DX Content Router consists of a server machine running Linux and executes one or both of two

services:

1. Publisher - processes all streams stored in a cluster, filters them based on stream metadata, and

publishes UUIDs to remote Subscribers.

2. Subscriber - retrieves UUID publications from remote Publishers. A Replicator, the most

common subscriber, retrieves remote UUIDs and sends replication requests to local nodes

and must be installed on a server in the same subnet as its target storage cluster. A 3rd party

application, which may or may not be installed on a node with other DX Content Router services,

can also function as a subscriber by integrating with the Enumerator API defined in the Appendix.

DX Content Router service configuration parameters are used to enable one or both services,

depending on the intended network topology. For the simple example in the previous section, where

a primary cluster replicates in one direction to a single DR cluster and all nodes in both clusters are

mutually visible, the DX Content Router in the primary cluster would likely be configured to run only

the Publisher service and the DX Content Router in the DR cluster would run just the Subscriber. A

slightly more complex example would be a pair of mirrored clusters where all nodes in both clusters

still have mutual visibility. DX Content Router servers for this topology would look like the diagram

below. For clarity, the assumed direct connections between storage nodes in the two clusters as

shown and discussed in the previous example have been omitted.

Version 2.2

December 2010