Dell DX6012S 설치 및 구성 매뉴얼 - 페이지 17

{카테고리_이름} Dell DX6012S에 대한 설치 및 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell DX6012S 35 페이지. Rack installation instructions — static rails
Dell DX6012S에 대해서도 마찬가지입니다: 보충 설명서 (4 페이지), 하드웨어 설치 지침 (2 페이지), 사용자 설명서 (46 페이지), 설정 및 구성 매뉴얼 (43 페이지), 시작하기 매뉴얼 (28 페이지), 공지 사항 (28 페이지), 공지 사항 (20 페이지), 개요 (19 페이지), 구성 매뉴얼 (9 페이지), 구성 매뉴얼 (9 페이지), 릴리스 노트 (8 페이지), 구성 매뉴얼 (7 페이지), 릴리스 노트 (6 페이지), 릴리스 노트 (5 페이지), 릴리스 정보 (5 페이지), 시작하기 매뉴얼 (47 페이지), 설치 (2 페이지), 랙 설치 (2 페이지)

Dell DX6012S 설치 및 구성 매뉴얼
where 172.20.0.0 is the desired new internal network interface.
Best practice is to reboot the DX Storage cluster from the DX Storage admin console and then
run the changeinternalnetwork script while the cluster is rebooting so that when the nodes come
back online they are assigned a new IP address from the new internal network interface range.
Alternatively, administrators may run the script and then manually power cycle the nodes; the DX
Storage admin console will no longer be able to route the reboot request after the internal network
has been updated. Several CSN processes, including the NTP server and DX Content Router
Publisher and Replicator, will be restarted when the script completes. After the Primary CSN has
changed its internal network and the storage cluster is back online, the Secondary CSN should also
have its internal network changed to the same as the Primary.

3.2. Modifying SNMP Access

The CSN installs the Net-SNMP command line tool for use in collecting SNMP data from the MIB.
The tool utilizes standard SNMP commands like 'snmpwalk', 'snmpget' and 'snmpset'. For read-
only commands (snmpwalk, snmpget), the CSN expects a password of 'public' by default. For write
commands, it expects a 'private' password by default. The default passwords may be updated from
the SNMP Access link under the Cluster Services tab of the CSN Console:

3.3. Updating the DX Storage software version

To update the version of DX Storage software being used in the storage cluster, you must install the
new rpm using the following command from a standard RHEL terminal window:
yum install [new DX Storage version]
After the install, a new DX Storage software version will appear on the Netboot Management page
of the Cluster Services tab of the CSN Console:
Copyright © 2010 Caringo, Inc.
All rights reserved
14
Version 2.0
December 2010