Dell EqualLogic FS7610 하드웨어 사용 설명서 - 페이지 11
{카테고리_이름} Dell EqualLogic FS7610에 대한 하드웨어 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell EqualLogic FS7610 32 페이지. Appliances
Dell EqualLogic FS7610에 대해서도 마찬가지입니다: 개요 (7 페이지), 설치 및 설정 매뉴얼 (46 페이지)
페이지 인쇄
Dell EqualLogic FS7610 Hardware Owner's Manual
The appliance turns on as soon as the power supplies are connected to a live power source.
Each controller contains a backup power supply (BPS). The BPS batteries begin to charge when the
appliance is connected to power. A full charge takes up to eight hours to complete; the NAS
appliance is not fully redundant until the battery is fully charged. The BPS provides the clustered
solution enough time to write all cached data to disk if the controller experiences a loss of power.
4. Check the LED on the front panel to make sure the appliance is operational (see
Turning Power On and Off
Normally, the appliance turns on when the power cables are connected to a source of live power. An LED
indicator on the front of the appliance indicates if power is supplied to the appliance and if the appliance is
operational. However, each controller has a power button on its back (the power LED) that enables you to turn
off power to an individual controller for service purposes.
In addition, the power supplies have an LED that shows if power is present or if a power fault has occurred, as
described in
Table
5.
LED Color and Patterns
OFF
Green
Amber
Figure 4: Secure the Power Cable with the Strain Relief
Table 5: Troubleshooting – Power Supply LED
Description
Power is not connected
Indicates that a valid power source is connected to the power supply and that
the power supply is operational
Indicates a problem with the power supply
1 Basic Appliance Information
Figure
2).
5