Dell EqualLogic PS5000 하드웨어 매뉴얼 - 페이지 32

{카테고리_이름} Dell EqualLogic PS5000에 대한 하드웨어 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell EqualLogic PS5000 50 페이지. Storage arrays
Dell EqualLogic PS5000에 대해서도 마찬가지입니다: 하드웨어 유지 관리 (46 페이지)

페이지 인쇄

–

Click Finish to complete the configuration and exit the wizard.

When you exit the wizard, it configures the group IP address as an iSCSI discovery address on the computer, if not

already present.

After you join a group, you can use the Group Manager GUI or CLI to create and manage volumes.

Computer Access To A Group

You can use the Remote Setup Wizard to enable Windows computer access to a Dell EqualLogic PS Series group. You

can also use the wizard to modify existing group access information on a computer (for example, if the group IP address

changed).

NOTE: When you create a group using the Remote Setup Wizard, computer access to the group is automatically

configured. This section applies only if you used Remote Setup Wizard on a different computer to create the group,

or created the group through the serial cable instead of Remote Setup Wizard.

When you use the Remote Setup Wizard to enable computer access to a group, the wizard performs the following:

1. Configures the group IP address as an iSCSI target discovery address. This enables the computer to discover

volumes and snapshots (iSCSI targets) in the group.

2. Stores the CHAP user name and password that allow Microsoft services (VDS or VSS) access to the group.

Enabling Computer Access To A Group

To enable computer access to a group or modify existing group access information:

Obtain the following information:

–

Name and IP address of the group.

–

CHAP user name and password already configured in the group for Microsoft service (VSS or VDS) access

to the group.

NOTE: To use the Group Manager GUI to display the VSS/VDS access control record, click Group Configuration →

VSS/VDS .

NOTE: To display the local CHAP account in the group, click Group Configuration → iSCSI.

Launch the Remote Setup Wizard.

In the Remote Setup Wizard - Welcome window, select Configure this computer to access a PS Series SAN, and

click Next.

In the Configuring Group Access dialog box, you can:

–

Click Add Group to add a group that the computer can access.

–

Select a group and click Modify Group to modify existing group access.

In the Add or Modify Group Information dialog box:

a) Specify or modify the group name and IP address, as needed.

b) If the group is configured to allow Microsoft service (VDS or VSS) access to the group through CHAP, specify

the CHAP user name and password that matches the VSS/VDS access control record and local CHAP account

already configured in the group.

c) If the PS Series group is configured to restrict discovery based on CHAP credentials, click the check box next

to Use CHAP credentials for iSCSI discovery.

d) Click Save.

In the Configuring Group Access dialog box, click Finish.

Configuring Multipath I/O Between A Computer And A Group

To configure multipath I/O between a computer and a group: