Dell PowerEdge 사용자 설명서 - 페이지 8

{카테고리_이름} Dell PowerEdge에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 20 페이지. Vmware esxi software on servers
Dell PowerEdge에 대해서도 마찬가지입니다: 포트폴리오 매뉴얼 (27 페이지), 빠른 매뉴얼 (6 페이지), 매뉴얼 사용 (44 페이지), 시스템 관리 매뉴얼 (28 페이지)

페이지 인쇄
Dell PowerEdge 사용자 설명서

Deploying 12 Gbps SAS HBA controller

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the system.
NOTE: For information about removing and reinstalling system parts, see the system-specfic
Owner's Manual at dell.com/poweredgemanuals.
This section provides a set of high level installation and removal instructions for the 12 Gbps SAS HBA
controller.

Installing 12 Gbps SAS HBA controller

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: To ensure protection for the electronic components inside, follow the ElectroStatic
Discharge (ESD) guidelines.
1.
Unpack your 12 Gbps SAS HBA controller.
2.
Turn off the system, including any attached peripherals, and disconnect the system from the
electrical outlet.
NOTE: For more information about Power Supply Units (PSUs), see your system's Hardware
Owner's Manual at dell.com/poweredgemanuals.
3.
Disconnect the system from the network and remove the cover of the system.
4.
If applicable, remove the blank.
5.
Select an appropriate PCIe slot.
NOTE: To avoid damage to the controller, hold the controller by its edges only.
6.
Align the connector on the 12 Gbps SAS HBA controller with the PCIe slot on the system.
7.
Press down the controller till the connectors are firmly engaged.
8.
Tighten the screws on the bracket, if any, or use the system's retention clips to secure the controller
on the system.
9.
Use SAS cable(s) to connect the external tape device or enclosure to the adapter.
10. Install the system cover.
11. Reconnect the power cable(s) and network cables, and then turn on the system.
8
2