Dell PowerEdge 시스템 관리 매뉴얼 - 페이지 12
{카테고리_이름} Dell PowerEdge에 대한 시스템 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 28 페이지. Vmware esxi software on servers
Dell PowerEdge에 대해서도 마찬가지입니다: 포트폴리오 매뉴얼 (27 페이지), 빠른 매뉴얼 (6 페이지), 매뉴얼 사용 (44 페이지), 사용자 설명서 (20 페이지)
페이지 인쇄
•
Power supply health status
–
System level for system board status along with power consumed in
watts
–
Power supplies health status along with power consumed in watts,
amps, and voltage
•
Voltage sensor health status along with reading (if applicable)
•
Health status for all the fans in the system along with RPM readings
•
Ambient temperature of the server with status
•
Software
–
Versions for software components including Dell storage controller
driver firmware, VMware ESXi hypervisor, and Dell BIOS for the
PowerEdge server
•
Health status of cable and interconnects
•
Chassis intrusion status
•
Watchdog timer status
•
CMOS battery health status
VMware Infrastructure Client updates the health status by polling every
90 seconds. The heath status can be updated by clicking Refresh at the top
right of the screen. The Power Reading sensors can be reset by clicking Reset
Sensors at the top right of the screen.
To configure the hardware components and to change the threshold of
supported components, refer to "Advanced System Configuration" on
page 14.
Alert Monitoring
IT Assistant can be configured to receive traps from ESXi. SNMP traps are
generated by the server for the following:
1 Hardware Event Alerts:
For each of the component listed in the previous section, an SNMP
a
trap is generated when status goes from green to yellow or green to
red. These traps are generated by the ESXi software and delivered
through the ESXi Management Network.
12
Systems Management Guide