Dell PowerEdge 4400 설치 매뉴얼 - 페이지 16

{카테고리_이름} Dell PowerEdge 4400에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 4400 20 페이지. Wake-on-lan (wol) support on dell servers
Dell PowerEdge 4400에 대해서도 마찬가지입니다: 설치 매뉴얼 (42 페이지), 설치 매뉴얼 (28 페이지), 랙 설치 (37 페이지), 업데이트 매뉴얼 (8 페이지), 정보 업데이트 (8 페이지), 사용자 설명서 (42 페이지), 랙 설치 (34 페이지), 하드웨어 설치 매뉴얼 (40 페이지), 설치 매뉴얼 (36 페이지), 매뉴얼 (15 페이지)

페이지 인쇄
Dell PowerEdge 4400 설치 매뉴얼
(Rev. 11/3/98) FILE LOCATION: S:\SYSTEMS\SlimFast\ts\ProcUpgrade\028WD\028wdeb0.fm
1-12
Microprocessor Upgrade Installation Guide
8SJUDGLQJ WKH 0LFURSURFHVVRU RU
,QVWDOOLQJ D 6HFRQGDU\ 0LFURSURFHVVRU LQ
3RZHU(GJH 6\VWHPV
Each microprocessor is contained within an SEC cartridge and heat sink assembly.
The system board has two guide-bracket assemblies, which hold the SEC cartridge
and heat sink assemblies. If your system has only one microprocessor, the secondary
guide-bracket assembly must contain a terminator card.
If you add a second microprocessor to the system, its maximum speed need not
match that of the primary microprocessor, but the internal operating speed of the
faster microprocessor will be reduced to match the speed of the slower
microprocessor.
5HPRYLQJ D 7HUPLQDWRU &DUG
To remove a terminator card, perform the following steps.
,QVWDOODWLRQ DQG 7URXEOHVKRRWLQJ *XLGH
1.
Turn off the system, including any attached peripherals, and disconnect the AC
power cable from its power source.
*XLGH
2.
Remove the computer cover.
3.
Remove the cooling shroud.
4.
Lift the latches on each end of the guide-bracket assembly (see Figure 1-7).
DELL CONFIDENTIAL - Preliminary
'HOO 3RZHU(GJH 6\VWHPV
,QVWDOODWLRQ DQG 7URXEOHVKRRWLQJ
9/11/00