Dell PowerEdge SC420 소유자 매뉴얼 - 페이지 20
{카테고리_이름} Dell PowerEdge SC420에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge SC420 26 페이지. Expansion enclosure
Dell PowerEdge SC420에 대해서도 마찬가지입니다: 교체 매뉴얼 (14 페이지), 시작하기 매뉴얼 (7 페이지), 정보 업데이트 (21 페이지), 소유자 매뉴얼 (21 페이지)
페이지 인쇄
Figure 13. Installing Dell Enterprise Hard Drives in an SC420 Expansion Enclosure
3.
Close the hard drive carrier handle to lock the hard drive in place.
4.
Continue to push firmly until you hear a click and the hard drive carrier handle fully engages.
5.
Insert drive blanks into any open slots in the expansion enclosure.
All of the drive slots in the expansion enclosure must be filled with a drive or drive blank.
Replacing Rack Rails
Rack rails are used to install SC400/SC420 expansion enclosures into a rack.
Prerequisites
1.
Use SupportAssist to send diagnostic data to Dell Technical Support Services.
2.
Shut down the storage system and expansion enclosures.
About this task
Use this procedure to replace rack rails.
NOTE: Replacing rack rails must be performed during a scheduled maintenance window when the
Storage Center system is unavailable to the network.
Steps
1.
Shut down the storage system.
2.
Remove the enclosure from the rack rails.
3.
Remove the rack rails from the rack.
4.
Install the replacement rack rails in the rack.
5.
Install the enclosure in the rack rails.
Next steps
1.
Start up the storage system and expansion enclosures.
20
Replacing SC400/SC420 Expansion Enclosure Components