Dell PowerVault 110T DLT VS160 사용자 설명서 - 페이지 8

{카테고리_이름} Dell PowerVault 110T DLT VS160에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault 110T DLT VS160 39 페이지. Compatibility guide
Dell PowerVault 110T DLT VS160에 대해서도 마찬가지입니다: 핸드북 (20 페이지), 매뉴얼 (50 페이지)

Dell PowerVault 110T DLT VS160 사용자 설명서
Getting Started and Setup: Dell PowerVault 110T DLT VS160 Tape Drive User's Guide
NOTE: Save the packing materials in case you need to move or ship your drive in the future. You must ship the
PowerVault 110T DLT VS160 Tape Internal drive in the original or equivalent packing materials or your warranty may be
invalidated.

Setting the SCSI ID

Regardless of the number of SCSI devices attached to the server that is to be the host for the PowerVault 110T DLT VS160 Tape
Internal drive, each must have a unique SCSI ID. Check the SCSI IDs on all other SCSI devices on the selected server, including
the SCSI host adapter, and select an unused SCSI ID for the PowerVault 110T DLT VS160 Tape Internal drive. The factory default
SCSI ID is 6. If another device is not already using the factory default SCSI ID, you do not need to change the drive's SCSI ID.
NOTE: If you attach the drive to a narrow (50-pin) bus, you can only use SCSI IDs 0 through 7.
Locate the SCSI ID jumpers on the rear panel of the drive as shown in Figure 1.
Figure 1. SCSI ID jumpers on rear panel of drive
To set the SCSI ID on the PowerVault 110T DLT VS160 Tape Internal drive, use the supplied jumpers to select the desired SCSI
ID as shown in
Table
1. After you change the SCSI ID, restart the host server to activate the new SCSI ID and to allow the server
to recognize the drive at the new ID.
Table 1. SCSI ID jumper settings
file:///C|/Users/rishi_sood/Desktop/Temp/MissingDocsPosted/110t_dlt/UG/setup.htm[3/8/2013 11:46:12 AM]