Dell PowerVault 122T LTO 사용자 설명서 - 페이지 2

{카테고리_이름} Dell PowerVault 122T LTO에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault 122T LTO 42 페이지. Lto autoloader
Dell PowerVault 122T LTO에 대해서도 마찬가지입니다: 사용자 설명서 (40 페이지), 핸드북 (28 페이지)

페이지 인쇄

Back to Contents Page

Autoloader Administration: Dell™ PowerVault™ 122T LTO Autoloader User's Guide

Configuring the Autoloader

Updating Firmware

Running the Autoloader System Test

Retrieving Information About the Autoloader

Configuring the Autoloader

The Configuration menu options enable you to perform the following tasks:

Resetting the autoloader

Setting SCSI IDs

Autoloader Operating Modes

Updating firmware

To access the Configuration menu from the Home screen or main menu, press + or - until Configuration appears on the top line of the LCD screen, press

Enter, and then press + or - to access the available options. Press Enter to execute the displayed menu option.

Resetting the Autoloader

This option resets the autoloader robotics and the tape drive within the autoloader, forces a new cartridge inventory, and clears any current error condition.

NOTE: This option is primarily used if the autoloader is in an error state.

To access this option, follow these steps:

1. From the Home screen or main menu, press + or - until Configuration appears on the top line of the LCD screen, then press Enter.

2. Press + or - until Reset appears on the LCD screen.

3. Press Enter to reset the autoloader.

4. After initialization, the autoloader returns to normal operation and displays the Home screen.

Changing the SCSI ID

This option changes the SCSI ID of the autoloader and/or tape drive. The autoloader occupies two SCSI IDs (target addresses), one is for the tape drive, the

other is for the autoloader robotics.

The default SCSI IDs are (5) for the autoloader, and (6) for the tape drive. You should only need to change the SCSI IDs if there is another device on the SCSI

bus using the same SCSI ID.

To access this option, follow these steps:

1. From the Home screen or main menu, press + or - until Configuration appears on the top line of the LCD screen, then press Enter.

2. Press + or - until Change SCSI ID appears on the LCD screen, and then press Enter.

3. Press + or - until the desired device is displayed, either Loader or Drive.

4. Press Enter. The LCD indicates either Change Loader ID or Change Drive ID depending on which device was selected. The second line will display New

SCSI ID: xx where xx is the current SCSI ID for that device.

5. Press + or - until the desired SCSI ID is displayed.

6. Press Enter. The LCD screen indicates Please Cycle Power. If you need to change the SCSI ID for the other device, go back to step 4 above.

7. Once both SCSI IDs are set correctly and the Please Cycle Power message is displayed, turn off the autoloader. After a few seconds, turn it back on

again.

The selected SCSI ID is now in effect.

NOTE: If you changed either SCSI ID, you may also need to reboot the host server and reconfigure your backup software before you can

use the autoloader. Consult your hardware and software manuals for more information.