Dell PowerVault 122T LTO 사용자 설명서 - 페이지 33
{카테고리_이름} Dell PowerVault 122T LTO에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault 122T LTO 42 페이지. Lto autoloader
Dell PowerVault 122T LTO에 대해서도 마찬가지입니다: 사용자 설명서 (40 페이지), 핸드북 (28 페이지)
페이지 인쇄
Back to Contents Page
Operating the Autoloader: Dell™ PowerVault™ 122T LTO Autoloader User's Guide
Operator's Panel Overview
Understanding the Menu Structure
Using Cartridges
Cleaning the Tape Drive
Creating an Inventory of Cartridges
Operator's Panel Overview
The Operator's Panel consists of four LEDs, four buttons, and a 2-line by 16-character LCD screen. The Operator's Panel provides everything you need to
monitor autoloader status and to control all of its functions.
The display defaults to the Home screen. The Home screen consists of the autoloader status on the top line and the current cartridge inventory on the second
line. If the tape drive does not have a cartridge loaded, the top line displays DELL PV-122T (see
The cartridge inventory indicates all slots that contain a cartridge by displaying the slot number. Empty slots are indicated by a dash or hyphen (-).
Home Screen
An exclamation point (!) displayed in the inventory indicates that the autoloader has identified a cartridge in the indicated slot that is either invalid or has had
a media error. These conditions can be caused by faulty media, possibly due to a corrupt imbedded servo signal, or dirty read/write heads in the tape drive.
The Media Attention LED is also illuminated in this case (see
Cartridges"). If these symptoms occur on multiple known good cartridges, consider cleaning the tape drive (see
cartridge causes these symptom repeatedly, that cartridge may be defective or invalid.
Occasionally you may see the message In Transit, which indicates:
An error condition has caused a cartridge to be left between its slot and the drive. (Power cycle or reset the autoloader to clear this condition.)
l
A cartridge is unexpectedly found in the Import/Export slot opening. (Power cycle or reset the autoloader to clear this condition.)
l
You may also see the message SEQ in the lower-right corner of the display. This message indicates that the autoloader is currently running in Sequential mode
(see
"Autoloader Operating
Modes").
If the tape drive has a cartridge loaded, the top line displays Drive loaded. The cartridge currently loaded in the drive is indicated by an alternating black block
and the slot number. This display can also indicate that the specified cartridge is being loaded, unloaded, imported, or exported, as well as indications of read
to, write to, and so on. The autoloader status line indicates the current operation. An example of this display is shown in the next section.
Home Screen, Drive Loaded
LED Indicators
The Operator's Panel includes four LED indicators that provide a variety of information as detailed in the following table:
LED
Color
Description
"LED
Indicators"). Exporting the indicated cartridge will clear the error condition (see
"Home
Screen").
"Cleaning the Tape
"Exporting
Drive"). If a particular