Dell PowerVault 715N 서비스 매뉴얼 - 페이지 27
{카테고리_이름} Dell PowerVault 715N에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault 715N 44 페이지. Network attached storage
Dell PowerVault 715N에 대해서도 마찬가지입니다: 업데이트 지침 (4 페이지), 사용자 설명서 (31 페이지)
페이지 인쇄
4. Install or replace the memory module(s) as necessary to reach the memory total you want (see
Modules" or
"Removing Memory
5.
Replace the system
6. Reconnect the system to the electrical outlet, and then turn on the system.
NOTE:
To perform the next step, you must use the console redirection function on the serial port
(COM1). See the System Administrator's Guide for more information about console redirection.
7. (Optional) Press <F2> to enter the
CMOS Setup screen.
NOTE:
If you use a version of Windows 2000 earlier than Service Pack 2, the function keys do not
work. You must press <Esc><2>.
The system should have already changed the value in the Extd Memory setting to reflect the
newly installed memory.
8. If the Extd Memory value is incorrect, one or more of the memory modules might not be installed properly.
Repeat steps 2–5, ensuring that the memory modules are firmly seated in their sockets.
9. Run the system memory test in the system diagnostics.
10. Replace the
system
Installing Memory Modules
CAUTION:
Before you perform this procedure, you must turn off the system and disconnect it from its
power source. For more information, see the safety instructions in your System Information document.
CAUTION:
See "Protecting Against Electrostatic Discharge" in the safety instructions in your System
Information document.
To install a memory module, perform the following steps.
CAUTION:
Read the safety instructions in your System Information document.
1. Turn off the system, including any attached peripherals, and disconnect the power cord from the electrical outlet.
2. Remove the
system
Modules").
cover.
BIOS Setup
cover.
cover.
utility, and then check the Extd Memory setting on the Standard
"Installing Memory