Dell PowerVault 735N 설치 매뉴얼 - 페이지 11
{카테고리_이름} Dell PowerVault 735N에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault 735N 26 페이지. Nas appliances.
boot hard-disk drive
Dell PowerVault 735N에 대해서도 마찬가지입니다: 보충 설명서 (3 페이지), 하드웨어 교체 매뉴얼 (10 페이지), 업데이트 매뉴얼 (10 페이지), 매뉴얼 (18 페이지), 업데이트 매뉴얼 (12 페이지), 업데이트 매뉴얼 (8 페이지), 교체 지침 매뉴얼 (19 페이지)
페이지 인쇄
support.dell.com
Installing the Rack Kit
NOTE: For instructions on installing the system itself, see "Installing the System in
the Rack" found later in this guide.
To install the rack kit in the rack, perform the following steps:
1.
Remove the rack's front and back doors.
2.
Install the slide assemblies in the rack.
The subsections that follow include instructions for performing these tasks.
Removing the Doors From a 24-U or 42-U Rack
You must remove the doors from the rack to provide access to the interior of the rack
and to prevent damage to the doors while installing the system.
This procedure provides instructions for removing doors from Dell 24-U and 42-U
racks. If you have a Dell PowerEdge 4210 rack, see the procedures contained in the
Dell PowerEdge 4210 Rack Installation Guide.
To remove the doors, perform the following steps.
CAUTION: To prevent personal injury due to the size and weight of the
doors, never attempt to remove the doors by yourself.
1.
Open the latch on the front door.
If you have a 24-U (1 U=1.75 inches) rack cabinet, unlock and twist the handle
clockwise and open the door (see Figure 1-2).
Rack Installation Guide
1-3