Dell PowerVault 775N 플랫폼 매뉴얼 - 페이지 4

{카테고리_이름} Dell PowerVault 775N에 대한 플랫폼 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault 775N 8 페이지. Storage servers
Dell PowerVault 775N에 대해서도 마찬가지입니다: 업데이트 매뉴얼 (10 페이지), 정보 업데이트 (26 페이지), 플랫폼 매뉴얼 (10 페이지), 정보 업데이트 (14 페이지), 구성 (9 페이지), 소프트웨어 업데이트 (1 페이지), 특징 (2 페이지)

페이지 인쇄

Installing Peripheral Components in Your Cluster Node

PCI/PCI-X Slots

This section provides configuration information for adding network adapters and RAID controllers

into your cluster nodes.

Installing the PERC Card

You must install the PERC card in a 64-bit PCI/PCI-X slot up to 133 MHz or a 32-bit, 33-MHz PCI

slot. See Table 1-2 for information about your specific system.

If you are using multiple PERC cards, Dell recommends that you install them on separate PCI

buses for load balancing.

Ensure that your system has the correct Windows driver. To verify your PERC driver, perform the

following steps:

Click the Start button, select Programs, select Administrative Tools, and click Computer

Management.

Select System Tools, select Device Manager, and click the + sign to expand SCSI and RAID

controllers. One or more PERC cards are listed.

Right-click the appropriate PERC card, select Properties, select the Driver tab, and verify the

driver version.

Updating the PERC Firmware

Ensure that your PERC firmware is updated to the latest version. See your PERC documentation

for information about downloading the latest firmware. See the Dell Support website located

support.dell.com for the latest firmware version.

Adding Peripherals to Your Cluster Nodes

CAUTION:

of the components inside the system. See your

safety precautions, working inside the computer, and protecting against electrostatic discharge.

NOTE:

To ensure that the SCSI or RAID controller attached to the boot drives initializes first, you might

have to change the device controller priority order using the system BIOS utility or physically change the

order of the RAID adapters. This process ensures that the Windows operating system numbers the boot

drives in the proper sequence.

Platform Guide

Only trained service technicians are authorized to remove the system cover and access any

System Information Guide

for complete information about