Dell PowerVault DL4000 핸드북 - 페이지 17
{카테고리_이름} Dell PowerVault DL4000에 대한 핸드북을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault DL4000 28 페이지. Setting up your dell powervault dl4000 backup to disk appliance
Dell PowerVault DL4000에 대해서도 마찬가지입니다: 배포 매뉴얼 (22 페이지), 릴리스 노트 (11 페이지), 시작하기 매뉴얼 (10 페이지), 매뉴얼 (4 페이지), 매뉴얼 (2 페이지), 시스템 시작하기 (2 페이지)
페이지 인쇄
Table 9. Characteristics of Expired LTO Cleaning Tape in Various Drives
Drive Type
Cleaning with a Good Tape
Dell PowerVault
No seven segment display
110T LTO-2
indicator.
Dell PowerVault
110T LTO-2-L
(Certance)
Dell PowerVault
110T LTO-2-L
(Tandberg)
Dell PowerVault
No seven segment display
110T LTO-3
indicator.
• Activity light blinks green.
• Ejects tape shorty after.
• Power light on solid green.
• Activity light on solid
green.
• Status light on solid amber.
• Ejects tape when
complete.
• Press and hold the Eject
button for 6 seconds. The
drive enters the service
mode indicated by all
LEDs flashing slowly.
• Press Eject twice. The
Activity LED flashes fast.
• Ejects tape shorty after.
• Activity light blinks green
• Ejects tape shorty after.
Cleaning with an Expired Tape
• Pre firmware 53Y3: No seven
segment display indicator. Activity
light blinks green but ejects tape
shortly after inserting.
• Firmware 53Y3 and newer:
– Seven segment display shows 7
– Activity light blinks amber
– Ejects tape shortly after
inserting. When tape is
completely removed, all light
indicators turn off.
• Power light on solid green.
• Activity light on solid green.
• Status light blinks amber.
• Ejects tape shortly after inserting.
• Cleaning light turns on.
• Activity light flashes.
• Fault light flashes.
• Cartridge hold in the drive
When pressing Eject button, the
cartridge is ejected and the Cleaning
light stays on.
• Seven segment display shows 7.
• Activity light blinks amber.
• Ejects tape shortly after inserting.
When tape is completely removed,
all light indicators turn off.
LTO Media Handbook
(continued)
17