Dell PowerVault DL4000 배포 매뉴얼 - 페이지 10

{카테고리_이름} Dell PowerVault DL4000에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault DL4000 22 페이지. Setting up your dell powervault dl4000 backup to disk appliance
Dell PowerVault DL4000에 대해서도 마찬가지입니다: 핸드북 (28 페이지), 릴리스 노트 (11 페이지), 시작하기 매뉴얼 (10 페이지), 매뉴얼 (4 페이지), 매뉴얼 (2 페이지), 시스템 시작하기 (2 페이지)

페이지 인쇄

Select the appropriate internet protocol for the selected interface.

You can choose IPv4 or IPv6.

The network details are displayed depending on the internet protocol you select.

To assign the internet protocol details, do one of the following:

–

To assign the selected internet protocol details automatically, select Obtain an IPV4 address automatically.

–

To assign the network connection manually, select Use the following IPv4 address and enter the following

details:

IPv4 Address or IPv6 Address

Subnet mask for IPv4 and Subnet prefix length for IPv6

Default Gateway

To assign the DNS server details, do one of the following:

–

To assign the DNS server address automatically, select Obtain DNS server address automatically.

–

To assign the DNS server manually, select Use the following DNS server address and enter the following

details:

Preferred DNS sever

Alternate DNS server

Click Next.

The Configure hostname and domain setting page is displayed.

For information on NIC teaming, see

Configuring Hostname And Domain Settings

You must assign a hostname for the appliance. It is recommended that you change the host name before starting

backups. By default, the hostname is the system name as assigned by the operating system.

NOTE: If you plan to change the host name, it is recommended that you change the hostname at this stage.

Changing the host name after completing the Appliance Configuration Wizard requires manually performing

several steps.

To configure the hostname and domain settings:

On the Configure hostname and domain setting page, to change the hostname for the appliance, in New hostname

enter an appropriate hostname.

If you do not want the appliance to join a domain, select No in Do you want this appliance to join a domain?

By default, Yes is selected.

To join the appliance to a domain, enter the following details:

–

Domain name

–

Domain user name

–

Domain user password

Click Next.

NOTE: Changing the hostname or the domain requires a reboot. After the reboot, the AppAssure Appliance

Configuration wizard is launched automatically. If the appliance is joined to a domain, then after the reboot,

you must login as a domain user with administrative privileges on the appliance.

The Configure SNMP Settings page is displayed.

Teaming Network

Adapters.