Dell PowerVault DL4000 배포 매뉴얼 - 페이지 13

{카테고리_이름} Dell PowerVault DL4000에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault DL4000 22 페이지. Setting up your dell powervault dl4000 backup to disk appliance
Dell PowerVault DL4000에 대해서도 마찬가지입니다: 핸드북 (28 페이지), 릴리스 노트 (11 페이지), 시작하기 매뉴얼 (10 페이지), 매뉴얼 (4 페이지), 매뉴얼 (2 페이지), 시스템 시작하기 (2 페이지)

Dell PowerVault DL4000 배포 매뉴얼

Post Installation Tasks

After completing the AppAssure Appliance Configuration wizard and the AppAssure Core Setup wizard, perform the
following procedures to ensure that your backup appliance and the servers the appliance is backing up are correctly
configured.

Review Retention Periods

AppAssure sets default retention periods that determine how often snapshots are taken and how long the snapshots are
retained. However, the retention periods must be based on the needs of your environment. For example, if you are
backing up servers that run frequently-changing, mission-critical data that is essential for business continuity,
snapshots must be taken more frequently.
To review and make changes to these retention periods, perform the following steps:
1.
Open the AppAssure Core console.
2.
Select the Configuration tab and then click Retention Policy.
3.
Adjust the retention policy based on the needs of your organization.
4.
Click Apply.

Adjust The Number Of Streams

By default, AppAssure is configured to allow three concurrent streams to the appliance. It is recommended that the
number of streams is equal to one more than the number of machines (agents) you are backing up. For example, if you
are backing up six agents, the Maximum Concurrent Transfers must be set to seven.
To change the number of concurrent streams:
1.
Select the Configuration tab and then click Settings.
2.
Select change in Transfer Queue.
3.
Change Maximum Concurrent Transfers to a number that is at least one more than the number of clients you are
backing up.

Check Connectivity To Clients

After configuring the AppAssure Appliance and Core, verify that you can connect to the machines you plan to back up.
To protect a machine:
1.
Navigate to the AppAssure 5 Core console, and select the Machines tab.
2.
In the Actions drop-down menu, click Protect Machine.
The Connect dialog box is displayed.
3.
In the Connect dialog box, enter the information about the machine to which you want to connect as described in
the following table.
3
13