Dell PowerVault DX6104 사용자 설명서 - 페이지 7

{카테고리_이름} Dell PowerVault DX6104에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault DX6104 39 페이지. Dx object storage platform
Dell PowerVault DX6104에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (8 페이지), 시작하기 매뉴얼 (10 페이지), 매뉴얼 (37 페이지), 릴리스 노트 (16 페이지), 매뉴얼 (12 페이지), 매뉴얼 (24 페이지), 매뉴얼 (23 페이지)

페이지 인쇄

DX Object Storage Platform Overview

Network Topologies

The Dell DX Object Storage Platform network consists of one or more DX Storage Clusters connected by DX Content

Router services through a network. There are many possible network topologies depending on the storage network

goals. All networks share the following features:

•

Two or more (minimum three recommended) DX Cluster Services Nodes that provide services to the storage

cluster.

•

Three or more DX Storage Nodes that provide data storage services.

•

Ethernet switches to enable required services within a storage cluster (private network) and access to the

storage nodes from outside the cluster (public network).

•

Services such as Domain Name System (DNS) and Dynamic Host Configuration Protocol (DHCP).

NOTE: DX Storage Cluster requires a dedicated internal network to ensure that the storage cluster traffic is

protected from unauthorized access. The dedicated network also ensures that the external or corporate network is

isolated from both the PXE boot server and cluster multicast traffic. Single networking is not supported.

The DX supports 1GbE and 10GbE network speeds. All network services required by the cluster are present in the DX

Cluster Services Node software bundle, and preinstalled on the Cluster Services Node. The DX Storage Cluster is

automatically configured with the defaults for all network parameters that must be sufficient for most simple

configurations. All network parameters can be set manually to support more complex configurations. For more

information about setting network parameters, see the

Storage Advanced Administration Guide at dell.com/support/manuals.

Network switch configuration depends on both the network topology and the customer environment. To ensure proper

functioning with default network parameters and to maximize cluster performance, it is recommended that you follow

the best practices listed below, while configuring both the private and public network switches:

•

Disable Link Aggregation Control Protocol (LACP) as the DX Object Storage Nodes bond the system NIC ports in

balanced-alb modes.

•

Disable jumbo frames.

•

Disable spanning tree protocol, if the switches are not being trunked.

•

Disable Flow Control.

•

Disable IGMP snooping.

NOTE: If IGMP snooping must be enabled, there must also be an IGMP querier enabled in the same

network (broadcast domain).

NOTE: If switches are trunked, enable spanning tree protocol and port fast on the data intensive ports.

NOTE: Use of jumbo frames is not recommended. Though they are supported, changes are required to both the DX

system and the network switches.

Contact Dell to customize the network configurations to meet the solution requirements. For more information about

configuring the network for the Dell DX Object Storage Platform, see "Network Topology" in the

Advanced Administration Guide at dell.com/support/manuals.

DX Object Storage Getting Started Guide and the DX Object

DX Object Storage