Dell PowerVault DX6112 사용자 설명서 - 페이지 18

{카테고리_이름} Dell PowerVault DX6112에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault DX6112 39 페이지. Dx object storage platform
Dell PowerVault DX6112에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (9 페이지), 시작하기 매뉴얼 (10 페이지), 매뉴얼 (10 페이지), 매뉴얼 (37 페이지), 릴리스 노트 (16 페이지), 매뉴얼 (12 페이지), 매뉴얼 (24 페이지), 매뉴얼 (23 페이지)

페이지 인쇄

NOTE: The DX Storage Node is preconfigured to network boot from the DX Cluster Services Node. The

network ports must be connected to the private network before the system is turned on.

Installing The System In A Rack

If the DX system includes a rail kit, locate the

instructions to install the rails in the rack unit and to install the DX system in the rack.

Cabling The Appliance

Getting Started Guide that shipped with your system and follow the instructions to attach the power and

Locate the

network cables to the DX system. Connect the network ports to the cluster's private network on the same IP subnet as

the other storage nodes. The DX Storage Node is preconfigured to network boot from the DX Cluster Services Node and

the NIC ports are preconfigured in balanced-alb modes.

Turning On The DX Storage Node

After cabling the storage node, turn it on, and verify that the network boot is successful.

NOTE: If the network boot is not successful, verify that the cables are correctly connected to the private network.

Enabling Capacity In DX Cluster Services Console

The DX Storage Cluster capacity is licensed. To expand the cluster capacity, you must purchase a capacity license. On

purchasing a capacity license, you receive a capacity license card that contains an activation code. Enter the activation

code in the DX Cluster Services console to enable the additional cluster capacity.

NOTE: The capacity is only applicable to the cluster in which it is entered.

To activate additional cluster capacity, follow the instructions in the

Configuration Guide .

Adding Network Adapter To DX Storage Nodes

You can add additional network adapters to the DX Storage Nodes to expand the network bandwidth to the storage

nodes.

To add additional network adapters:

Turn off the DX Storage Node.

To add a network adapter, follow the steps in the DX Storage Node's

Connect the Ethernet ports to the private network.

See the figure in

Adding Network Adapters to DX Cluster Services

Turn on the DX Storage Node.

The DX Storage Node is automatically configured with all network ports bonded.

Rack Installation Instructions supplied with the rail kit. Follow the

Cluster Services Node Installation and

Nodes.

Owner's Manual at dell.com/support/manuals.