Dell PowerVault MD1000 정보 업데이트
{카테고리_이름} Dell PowerVault MD1000에 대한 정보 업데이트을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD1000 18 페이지. Dl backup to disk appliance - powered by commvault
Dell PowerVault MD1000에 대해서도 마찬가지입니다: 지원 매트릭스 매뉴얼 (11 페이지), 참조 매뉴얼 (35 페이지), 지원 매트릭스 (21 페이지), 보충 설명서 (2 페이지), 정보 업데이트 (42 페이지), 설정 다이어그램 (2 페이지)

Information Update
This document provides updated information regarding the Dell
Storage Enclosure.
Loss of Communication Between the Dell PERC 5/E Adapter
and the Dell PowerVault MD1000 Storage Enclosure
The following activities may cause loss of communication to occur:
•
Installing or replacing an enclosure management module (EMM) while the server is online
•
Downloading PowerVault MD1000 firmware
•
Accidentally disconnecting the cables to the enclosure or EMM while the server is online
•
Powering down the PowerVault MD 1000 enclosure while the server is online
NOTE:
In a split-mode configuration, these conditions apply to the server that is directly attached to the
affected EMM. In a daisy-chain configuration, these conditions apply when communication is lost to any
enclosure in the daisy chain.
Loss of Communication Messages
When a loss of communication scenario occurs, the following messages could be reported by the
PERC 5/E Adapter Ctrl-R utility and the Dell OpenManage
logged as a result of a loss of communication and they do not indicate actual hardware
component failures.
•
The PERC 5/E Adapter Ctrl-R utility may report:
–
Physical disks and virtual disks as Offline, Degraded, Failed, or Foreign
•
The Dell OpenManage Server Administrator Storage Management may report:
–
Lost Communication alert(s) to the Dell OpenManage Server Administrator Alert Log
–
The enclosure, physical disks, and virtual disks as Offline, Degraded, Failed, or Foreign
Resolving a Loss of Communication Scenario
Perform the following steps when a loss of communication scenario occurs:
1 Power down the server.
2 Verify that all the cables are properly connected and secured to the Dell PERC 5/E Adapter
and the Dell PowerVault MD1000 enclosures.
™
™
PowerVault
MD1000
™
applications. These messages are
April 2006