Dell PowerVault MD2460 소유자 매뉴얼 - 페이지 21

{카테고리_이름} Dell PowerVault MD2460에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD2460 47 페이지. Direct-attach storage for poweredge servers

Install the drive carrier in the enclosure

Steps

1. Open the release handle on the drive carrier.

2. Align the drive carrier with the target slot and gently push the drive carrier into the slot.

3. Close the release handle to lock the drive in place.

Verify that the activity light flashes to indicate that the spin-up sequence has begun.

Figure 19. Install the drive carrier in the enclosure

The following list describes the ideal installation pattern providing the best airflow and thermal performance:

● Populate the slots from the rear of the enclosure first, closest to the PSU.

● The minimum number of drives in an enclosure is 12.

● If it is not possible to fill a complete row, insert drive blanks to fill the empty slots in each row.

● Do not partially populate multiple rows. Fill each row before proceeding to the next row.

Once you have installed all the drives, install the system cover.

Steps

1. Position the system cover on top of the enclosure and slowly slide it back towards the rear of the enclosure until it stops.

2. Tighten the two thumbscrews to secure the system cover.

Installing the enclosure