Dell PowerVault MD3000i 사용자 설명서 - 페이지 22

{카테고리_이름} Dell PowerVault MD3000i에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3000i 46 페이지. Configuration for vmware esx server software
Dell PowerVault MD3000i에 대해서도 마찬가지입니다: 튜닝 매뉴얼 (32 페이지), 지원 참고 사항 (22 페이지), 업그레이드 매뉴얼 (28 페이지), 교체 매뉴얼 (4 페이지), 구성 매뉴얼 (10 페이지)

페이지 인쇄

3 Verify vmhba33 configuration:

esxcli swiscsi nic list -d vmhba33

Both vmk1 and vmk2 should be listed.

In this example, if you use the vSphere client to display the Paths view for the

vmhba33 initiator, you can see that it uses two different paths to access the

same target. The runtime names of the paths are vmhba33:C1:T1:L0 and

vmhba33:C2:T1:L0. C1 and C2 in this example indicate the two network

adapters that are used for multipathing.

ESX Host Configuration Wizard

To use the Automatic Host Configuration utility:

1 Navigate to Hosts and Clusters within the vSphere Client, select the ESX

host to be configured.

2 Right-click on the ESX host, and select the Configure ESX Host to

Storage Array option from the drop-down menu. See Figure 14.

This will launch the Configure ESX Host to Storage Array wizard. See

Figure 15.

From this wizard, you can view the current ESX host configuration to

the storage array (if it is already configured). You can also add a host or

host group, rename a host or host group, remove a host or host group

and automatically configure the ESX host to another storage array.

3 To automatically configure the ESX host to the Dell storage array, click

the storage array to be configured, and click the Suggest button.

This action will define a new host and host group and add all unassigned

IQN ports to that host. See Figure 15.

4 If the suggested configuration is correct, click OK to apply the changes

to the storage array.

If the suggestion is not correct, modify the configuration based on the

iSCSI zoning rules from the previous ESX Host SAN Configuration

section.

Dell MD Storage Array vCenter Plug-in