Dell PowerVault MD3000i 구성 매뉴얼 - 페이지 4

{카테고리_이름} Dell PowerVault MD3000i에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3000i 10 페이지. Configuration for vmware esx server software
Dell PowerVault MD3000i에 대해서도 마찬가지입니다: 튜닝 매뉴얼 (32 페이지), 지원 참고 사항 (22 페이지), 업그레이드 매뉴얼 (28 페이지), 사용자 설명서 (46 페이지), 교체 매뉴얼 (4 페이지)

페이지 인쇄

3. iSCSI Connectivity Support

Operating System

VMware ESX Server 3.5

4. PowerVault MD3000i Storage Setup and Configuration

Create virtual disks on MD3000i using steps described in:

http://support.dell.com/support/edocs/systems/md3000i/en/IG/PDF/IGbk0HR.pdf.

After opening the Modular Disk Storage Manager and selecting the MD3000i storage array to be

configured, select the Configure tab.

Note: in the examples to follow the Storage array "sg23_training" is an MD3000i with

virtual disks already configured using the Create Virtual Disks selection. The new server

being added to an existing host group is named "Valhalla".

From the Configure tab

1. Select Configure Host Access (Manual).

2. Enter the host name for the server which has the ESX Server software is installed.

3. Select Linux as the host type.

From the next screen, specify the iSCSI Initiator by selecting the New button (lower right on

screen). On the Enter New iSCSI Initiator screen enter a name for the iSCSI initiator name. The

label is auto-populated from the server name.

Host Group configuration starts from the following screen titled "Configure Host Access (Manual)

– Specify Host Group". For ESX servers supporting VMotion, HA, and DRS, a host group must be

defined so the MD3000i storage subsystem has a configured iSCSI path to each of the hosts.

Select "Yes: This host will share access to the same virtual disks with other hosts"

If a new host group is desired select the radio button for that option and enter in a name

for your host group using standard host naming conventions (e.g. no spaces etc).

Should you already have one or more host groups assigned, select the radio button

enabling selection from a drop down list of existing host groups. This option is to be

used when configuring the second, third, etc. host in a group. Once the host group is

selected previously configured hosts for that host group will be displayed. Note that

Dell Inc

iSCSI software initiator with ESX Server

Figure 2: iSCSI Initiator Window

Host Bus Adapter

Page 4