Dell PowerVault MD3060e Series 관리자 매뉴얼 - 페이지 40

{카테고리_이름} Dell PowerVault MD3060e Series에 대한 관리자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3060e Series 48 페이지. Storage enclosure
Dell PowerVault MD3060e Series에 대해서도 마찬가지입니다: 하드웨어 및 소프트웨어 매뉴얼 (25 페이지), 설치 매뉴얼 (11 페이지), 시작하기 매뉴얼 (10 페이지), 정보 업데이트 (8 페이지), 랙 설치 지침 (2 페이지), 설정 (2 페이지), 배포 매뉴얼 (24 페이지), 관리자 매뉴얼 (35 페이지), 시작하기 매뉴얼 (10 페이지), 배포 매뉴얼 (24 페이지), 소유자 매뉴얼 (40 페이지), 설정 (2 페이지)

페이지 인쇄
Dell PowerVault MD3060e Series 관리자 매뉴얼
The SHM Monitor configuration file is located in the installation directory. The following is the default
location of the configuration files.
Table 30. Log File Location
Operating
Log File Location
System
Windows
C:\Program Files\Dell\ServerHardwareManager\ServerHardwareManagerMonitor
\SHM_Snmp.conf
Although the SHM Monitor runs automatically upon installation, you must configure a trap destination in
the configuration file for SNMP to function correctly. A trap destination has the following format:
ip=ipaddress[:port]
For example:
ip=192.168.1.1:1050
•
Address — The IP address of the destination
•
Port — Port on the target machine the trap receiver listens
Refer to the documentation of the trap listener for the port number it uses. If no port is specified, SHM
Monitor sends traps to the default port– 162.
NOTE: After any changes are made to the SNMP configuration file, you must stop and start the
service for changes to take effect.

Critical events

The SHM Monitor logs all event types. However, SNMP sends only critical events to the trap destination.
The list here outlines the critical events:
•
Power Supply Unit (PSU)
– PSU is removed
– DC voltage goes out of range of safe operating values
– DC current goes out of range of safe operating values
•
Fan is removed
•
Temperature Sensor
– Temperature of enclosure is above/below critical threshold
•
Voltage Sensor
– Voltage goes above or below a critical threshold
– AC power failure
– DC power failure
•
Drawer
– Drawer is opened
40