Dell PowerVault MD3200 Series 배포 매뉴얼 - 페이지 10

{카테고리_이름} Dell PowerVault MD3200 Series에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3200 Series 38 페이지. Storage arrays
Dell PowerVault MD3200 Series에 대해서도 마찬가지입니다: 업데이트 매뉴얼 (32 페이지), 랙 설치 지침 (2 페이지), 지원 매트릭스 (12 페이지), 설치 매뉴얼 (18 페이지), 배포 매뉴얼 (38 페이지), 정보 업데이트 (1 페이지), 지원 매트릭스 (17 페이지), 기술 매뉴얼북 (40 페이지), 백서 (22 페이지), 배포 매뉴얼 (38 페이지)

Connecting the Storage Array

The storage array is connected to a host using two hot-swappable RAID

controller modules. The RAID controller modules are identified as RAID

controller module 0 and RAID controller module 1.

For more information, see the Getting Started Guide.

Each RAID controller module has four SAS In port connectors that provide

SAS connections to the host or node. Each RAID controller module also

contains an Ethernet management port and a SAS Out port connector. The

Ethernet management port allows you to install a dedicated management

station (server or stand-alone system). The SAS Out port allows you to

connect the storage array to optional expansion enclosures for additional

storage capacity. For more information, see the Getting Started Guide.

Each Dell PowerVault MD3200 series storage array can be expanded to a

maximum of 120 (or 192, if enabled through the Premium Feature activation)

physical disks through a maximum of seven PowerVault MD1200 series

expansion enclosures.

NOTE:

When you connect a host server to a storage array SAS In port connector,

any Out port connector of the server's host bus adapter (HBA) can be used.

You can cable the storage array to host servers with:

•

Single path data configuration—A single path configuration allows you to

connect a maximum of eight hosts. This is a non-redundant configuration.

•

Dual path data configuration—A dual path configuration allows you to

connect a maximum of four hosts.

Choose the data configuration based on:

•

Number of hosts required

•

Level of data redundancy required

Hardware Installation