Dell PowerVault MD3200i Series 지원 매트릭스 - 페이지 3

{카테고리_이름} Dell PowerVault MD3200i Series에 대한 지원 매트릭스을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3200i Series 11 페이지. Storage arrays
Dell PowerVault MD3200i Series에 대해서도 마찬가지입니다: 배포 매뉴얼 (41 페이지), 업데이트 매뉴얼 (32 페이지), 랙 설치 지침 (2 페이지), 사용자 설명서 (46 페이지), 지원 매트릭스 (12 페이지), 설치 매뉴얼 (18 페이지), 정보 업데이트 (1 페이지), 지원 매트릭스 (17 페이지), 기술 매뉴얼북 (38 페이지), 백서 (22 페이지), 매뉴얼 (16 페이지)

페이지 인쇄

1. Support Hard Disk Drives

be run in unified mode.

A hot spare for a disk group

must be a physical disk of

equal or greater size than

any of the member disks.

When using out-of-band

management with SMcli by

specifying the RAID

Controller management port

IP addresses on the MD

Storage Array, SMcli

commands that change the

attributes of a virtual disk,

virtual disk copy, or snapshot

virtual disk, must have

management access to the

owning RAID Controller

Module to complete. Where

applicable it is a best practice

to specify both management

port IP addresses on the

SMcli invocation: "SMcli

192.168.128.101

192.168.128.102 -c".

Co-existence of multiple

Linux multi-pathing drivers is

not supported. When using a

MD3200 Series or MD3600

Series array with Linux host

servers only the Linux

Device Mapper failover driver

is supported.

On Linux systems Device

Mapper multi-pathing drivers

are required for multi-path

support

Virtual disks on an MD3200

Series or MD3600 Series

cannot be used for booting.

RAID 5 and RAID 6 disk

groups are limited to a

maximum of 30 physical

disks

Disk Groups can be migrated

between a Dell PowerVault

MD3200 or MD3200i or

MD3600i by following the

appropriate Disk Group

migration procedure***

All iSCSI Host ports on a

controller have to be at the

same port speed

iSCSI Host ports will only

auto-negotiate to the port

speed set in MDSM

Only single path iSCSI boot

is supported for all Linux

OS's. Multi-path iSCSI boot

on Linux is not supported.

√

Not Applicable for SAS

√

Only 1Gbps Supported

√