Dell PowerVault MD3220 Series 배포 매뉴얼 - 페이지 29

{카테고리_이름} Dell PowerVault MD3220 Series에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3220 Series 38 페이지. Storage arrays
Dell PowerVault MD3220 Series에 대해서도 마찬가지입니다: 업데이트 매뉴얼 (32 페이지), 랙 설치 지침 (2 페이지), 사용자 설명서 (46 페이지), 배포 매뉴얼 (38 페이지), 정보 업데이트 (1 페이지), 기술 매뉴얼북 (40 페이지), 배포 매뉴얼 (38 페이지)

페이지 인쇄

1. Cabling Powervault Md1200 Series Expansion Enclosures

Post Installation Tasks

Before using the Dell PowerVault MD storage array for the first time,

complete the set of initial configuration tasks in the order shown. These tasks

are performed using the MD Storage Manager (MDSM) software.

1 For out-of-band management, you must set the network configuration for

each RAID controller module, including its Internet Protocol (IP) address,

subnetwork mask (subnet mask), and gateway.

NOTE:

You can set the network configuration using a DHCP server.

2 Start MDSM.

•

Click StartProgramsDellMD Storage ManagerModular

Disk Storage Manager Client on Microsoft Windows operating

systems.

Click the PowerVault MD Storage Manager desktop icon on Linux

•

operating systems.

•

You can also launch PowerVault MD Storage Manager in Linux by

running the following commands at the command prompt:

cd/opt/dell/mdstoragesoftware/mdstoragemanager

/client./SMclient

3 Go to Setup Add Storage Array and start the automatic discovery of

systems in the Enterprise Management Window (EMW).

NOTE:

Only storage arrays configured with IP address on the same subnet as

the management stations will be detected.

NOTE:

It may take several minutes for the discovery process to complete.

Closing the Automatic Discovery Status window before this stops the

discovery process.

After discovery is complete, a confirmation screen is displayed.

4 Click Close to close the screen.

Post Installation Tasks