Dell PowerVault MD3220i Series 배포 매뉴얼 - 페이지 35

{카테고리_이름} Dell PowerVault MD3220i Series에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3220i Series 41 페이지. Storage arrays
Dell PowerVault MD3220i Series에 대해서도 마찬가지입니다: 업데이트 매뉴얼 (32 페이지), 랙 설치 지침 (2 페이지), 설치 매뉴얼 (18 페이지), 정보 업데이트 (1 페이지), 기술 매뉴얼북 (38 페이지), 매뉴얼 (16 페이지)

페이지 인쇄

1. Powervault Md32Xxi Storage Setup and Configuration

Dell PowerVault MD32xxi Configuration Guide for VMware ESX4.1 Server Software

Step A3: Assign Network Adapters

Just like in the previous example, the next step in the process is to assign the network adapters (NICs) that

will be attached to the iSCSI network and used for iSCSI traffic. These will be attached to the vSwitch2 that

we created earlier. This can be done two ways, in the vCenter GUI or by CLI.

To list all of the adapters in the system run the following command:

esxcfg-nics –l

This will list all of the adapters in the system. Assign the NICs that are physically connected to the SAN

infrastructure and to the vSwitch. The following command assumes that we are assigning vmnic2 and

vmnic3 to the vSwitch.

esxcfg-vswitch –L vmnic2 vSwitch2

esxcfg-vswitch –L vmnic3 vSwitch2

Once again to verify the configuration type the following command to list the vSwitch information:

esxcfg-vswitch –l

Your output will look similar to the following. Note the new vmnics that were assigned to the vSwitch

under uplinks.

Switch Name Num Ports Used Ports Configured Ports MTU Uplinks

vSwitch2

PortGroup Name VLAN ID Used Ports

iSCSI6

iSCSI5

iSCSI4

iSCSI3

iSCSI2

iSCSI1

This can also be configured and verified in the vCenter GUI. Remember that the polling of vCenter is not

instant so a refresh might need to occur to see the latest changes. To configure this same process from

the GUI, first navigate to the Networking section on the ESX host you are configuring. Configuration ->

Networking.

From here, click Properties on the vSwitch2.

Uplinks

9000 vmmnic3,vmnic2

vmnic2,vmnic3

Page 33