Dell PowerVault MD3600f Series 배포 매뉴얼 - 페이지 12

{카테고리_이름} Dell PowerVault MD3600f Series에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3600f Series 36 페이지. Remote replication
Dell PowerVault MD3600f Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (22 페이지), 설치 매뉴얼 (18 페이지), 지원 매트릭스 (17 페이지), 기능 매뉴얼 (15 페이지)

페이지 인쇄

About the Storage Array Connections

The storage array is connected to a host using two hot-swappable RAID

controller modules. The RAID controller modules are identified as RAID

controller module 0 and RAID controller module 1. For more information, see

the Getting Started Guide at support.dell.com/manuals.

Each RAID controller module has four FCIN (host) port connectors that

provide FC connections to the host or node. Each RAID controller module

also contains an Ethernet management port and a SAS Out port connector.

The Ethernet management port allows you to install a dedicated

management station (server or stand-alone system). The SAS Out port allows

you to connect the storage array to optional expansion enclosures for

additional storage capacity. For more information, see the Getting Started

Guide at support.dell.com/manuals.

NOTE:

When you connect a host server to a storage array FCIN port connector,

any Out port connector of the server's host bus adapter (HBA) can be used.

Cabling the Storage Array

You can cable the storage array to host servers with:

•

Single path data configuration—A single path configuration allows you to

connect a maximum of eight hosts. This is a non-redundant configuration.

•

Dual path data configuration—A dual path configuration allows you to

connect a maximum of four hosts.

You choose the data configuration based on:

•

Number of hosts required

•

Level of data redundancy required

Redundant and Non-Redundant Configurations

Non-redundant configurations are configurations that provide only a single

data path from a host to the storage array. This type of configuration is only

recommended for non-critical data storage. Path failure from a failed or

removed cable, a failed HBA, or a failed or removed RAID controller module

results in loss of host access to storage on the storage array.

Hardware Installation