Dell PowerVault MD3600i Series 지원 매트릭스 - 페이지 3
{카테고리_이름} Dell PowerVault MD3600i Series에 대한 지원 매트릭스을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3600i Series 17 페이지. Storage arrays
Dell PowerVault MD3600i Series에 대해서도 마찬가지입니다: 지원 매트릭스 (12 페이지), 지원 매트릭스 (11 페이지), 설치 매뉴얼 (18 페이지)
페이지 인쇄
enclosures for a total of 96
SAS physical disks is
supported.
Attached MD1200 series
expansion enclosures must
be run in unified mode.
A hot spare for a disk
group must be a physical
disk of equal or greater
size than any of the
member disks.
When using out-of-band
management with SMcli by
specifying the RAID
Controller management
port IP addresses on the
MD Storage Array, SMcli
commands that change the
attributes of a virtual disk,
virtual disk copy, or
snapshot virtual disk, must
have management access
to the owning RAID
Controller Module. Where
applicable it is best
practice to specify both
management port IP
addresses on the SMcli
invocation: SMcli
192.168.128.101
192.168.128.102 -c.
Co-existence of multiple
Linux multi-pathing drivers
is not supported. When
using a MD3200 or
MD3600 series array with
Linux host servers only the
Linux Device Mapper
failover driver is supported.
**
On Linux systems Device
Mapper multi-pathing
drivers are required for
multi-path support
Virtual disks on an
MD3200 or MD3600 series
cannot be used for booting.
RAID 5 and RAID 6 disk
groups are limited to a
maximum of 30 physical
disks
Disk Groups can be
migrated between a Dell
PowerVault MD3200 or
MD3200i or MD3600i by
following the appropriate
Disk Group migration
procedure***
All iSCSI Host ports on a
controller have to be at the
same port speed
iSCSI Host ports will only
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
N/A
Only 1Gbps Supported
N/A
Only 1Gbps Supported
√
√
√
√
√
√
√
√
√
√
√
MD3600f will
support boot from
SAN
√
√
√
√
√
N/A
√
N/A
3