Dell PowerVault MD3820f series 소유자 매뉴얼 - 페이지 21

{카테고리_이름} Dell PowerVault MD3820f series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3820f series 47 페이지. Storage arrays
Dell PowerVault MD3820f series에 대해서도 마찬가지입니다: 배포 매뉴얼 (34 페이지), 시작하기 매뉴얼 (8 페이지)

페이지 인쇄

Figure 13. Removing and Installing a Hot-Swap Physical Drive

release button

physical-drive carrier handle

Installing a Hot-Swap Physical Drive

CAUTION: Many repairs may only be done by a certified service technician. You should only

perform troubleshooting and simple repairs as authorized in your product documentation, or as

directed by the online or telephone service and support team. Damage due to servicing that is

not authorized by Dell is not covered by your warranty. Read and follow the safety instructions

that came with the product.

CAUTION: Use only physical drives that have been tested and approved for use with the physical-

drive backplane.

CAUTION: Combining SAS and SATA physical drives in the same RAID volume is not supported.

CAUTION: When installing a physical drive, ensure that the adjacent drives are fully installed.

Inserting a physical-drive carrier and attempting to lock its handle next to a partially installed

carrier can damage the partially installed carrier's shield spring and make it unusable.

CAUTION: To prevent data loss, ensure that your operating system supports hot-swap drive

installation. See the documentation supplied with your operating system.

CAUTION: When a replacement hot swappable hard drive is installed and the system is powered

on, the hard drive automatically begins to rebuild. Make absolutely sure that the replacement

hard drive is blank or contains data that you wish to have over-written. Any data on the

replacement hard drive is immediately lost after the hard drive is installed.

If a physical-drive blank is installed in the physical-drive slot, remove it.

Install a physical drive in the physical-drive carrier.

Press the release button on the front of the physical-drive carrier and open the physical-drive carrier

handle.

Insert the physical-drive carrier into the physical-drive slot until the carrier connects with the

backplane.

Close the physical-drive carrier handle to lock the physical drive in place.

physical drive