Dell PowerVault MD3820f series 소유자 매뉴얼 - 페이지 25

{카테고리_이름} Dell PowerVault MD3820f series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3820f series 47 페이지. Storage arrays
Dell PowerVault MD3820f series에 대해서도 마찬가지입니다: 배포 매뉴얼 (34 페이지), 시작하기 매뉴얼 (8 페이지)

페이지 인쇄

CAUTION: If your configuration uses fiber-optic cables, remember that they are fragile. Bending,

twisting, folding, or pinching fiber-optic cables can cause damage to the cables, degraded

performance, or loss of data. To prevent damage, do not twist, fold, pinch, or step on the cables.

Do not bend the cables in less than a 5 cm (2 inch) radius.

If small form-factor pluggable (SFP) transceivers are present, record the ports in which they are

installed, and remove them.

Take the desired RAID controller module offline.

Disconnect the cables connected to the RAID controller module.

If fiber-optic cables are present, it may be necessary to partially remove the RAID controller module

using the two release levers. Opening the release levers makes it easier to press down the fiber-optic

cable release tab. If the system is still running, do not disturb the second RAID controller module.

Push down on the release tab and pull the release lever away from the chassis.

Grasp the release lever and pull the module away from the chassis.

NOTE: To avoid damage to the sensitive EMI contacts on the RAID controller module, do not

stack RAID controller modules.

Figure 17. Removing and Installing a RAID Controller Module

RAID controller module

release lever

Installing a RAID Controller Module

WARNING: Fiber optic cables are fragile. Bending, twisting, folding, or pinching fiber optic cables

can cause damage to the cables, degraded performance, or loss of data. To prevent damage, do

not twist, fold, pinch, or step on the cables. Do not bend the cables in less than a 5 cm (2") radius.

release tab