Dell PowerVault Series 복구 매뉴얼 - 페이지 15

{카테고리_이름} Dell PowerVault Series에 대한 복구 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault Series 40 페이지. Data protection solution system

Operating System Reinstallation

This section describes the process of reinstalling the operating system on your

PowerVault system.

NOTE:

Your operating system was pre-installed when you purchased your system.

Only perform the steps in this section if required to repair a non-functioning

operating system.

Using the Dell Systems Build and Update Utility

Use the Dell Systems Build and Update Utility CD that came with your

solution to reinstall the operating system. The Systems Build and Update

Utility installs the operating system software, device drivers, and

OpenManage™ Server Administrator (OMSA) software.

Your system is factory-installed with Microsoft

Server

2003 R2 X64 with SP2. The Dell Systems Build and Update Utility

will need the original Microsoft installation media in order to install the

operating system.

NOTE:

Using the Dell Systems Build and Update Utility erases all data from the

virtual disk where you are installing the operating system.

To reinstall the operating system, perform the following steps:

1 Connect a keyboard, mouse, and monitor to your system.

2 Power on your system.

3 Insert the Dell Systems Build and Update Utility CD into the system's

optical drive and configure the BIOS setting to boot off that drive.

4 Reboot the system.

5 After the system boots from the CD, the System Build and Update Utility

screen appears (see Figure 4-1).

6 Select the appropriate language and keyboard type on the left side of the

screen and select the Server OS Installation option under the Single

Server Solution section.

Windows

Storage

Operating System Reinstallation