Dell PS6000X 하드웨어 매뉴얼 - 페이지 33

{카테고리_이름} Dell PS6000X에 대한 하드웨어 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PS6000X 50 페이지. Equallogic
Dell PS6000X에 대해서도 마찬가지입니다: 개요 (7 페이지), 빠른 참조 매뉴얼 (2 페이지)

페이지 인쇄

Start the Remote Setup Wizard.

In the Welcome dialog box, select Configure MPIO settings for this computer, and click Next.

The Configure MPIO Settings dialog box is displayed.

By default, all host adapters on all subnets that are accessible by the PS Series group are configured for multipath

I/O. If you want to exclude a subnet, move it from the left panel to the right panel. Also, select whether you want to

enable balancing the I/O load across the adapters.

NOTE: To exclude a specific IP address on a subnet, manually edit the registry variables. For more information, see

the

Host Integration Tools Release Notes .

Click Finish to complete the multipath I/O configuration. Click Back to make changes, if required.

Changes to the list of included or excluded subnets are effective immediately for new connections, while changes to

existing connections may take several minutes.

Configuring Firewall To Allow ICMP Echo Requests

If you are using Windows firewall on your system, configure your firewall to allow Internet Control Message Protocol

(ICMP) echo requests for ICMPv4.

To configure your firewall:

NOTE: This procedure is applicable for Windows Server 2008 only. For other versions of Windows operating

systems, see the documentation that is shipped with your system.

Click Start → Administrative Tools → Windows Firewall with Advanced Security.

Click Inbound Rules in the Main pane and New Rule in the Actionspane.

Check Custom and click Next.

Check All programs and click Next.

Select ICMPv4 from the Protocol type drop-down menu.

Click Customize Internet Control Message Protocol (ICMP) settings.

Check Specific ICMP types and then check Echo request.

Click OK and then, Next.

Specify the local and remote IP addresses. For each type (local or remote), check Any IP Address or These IP

addresses. If you check the latter, you must also type in one or more IP addresses. Click Next when you have

finished specifying IP addresses.

10. Check Allow the connection, and click Next. Look for the options under the label: When does this rule apply?

11. Check one of the following options:

–

Domain

–

Private

–

Public

12. Click Next.

13. Enter a name for this rule and an optional description.

14. Click Finish.

Installing The Microsoft iSCSI Software Initiator

This section is applicable to those Windows Server 2003 operating systems where the Host Integration Tools are not

used to install the initiator. The Host Integration Tools include a version of the Microsoft iSCSI Software Initiator. For

information on the supported iSCSI Software Initiator version, see the

dell.com/ha. If the version in the Host Integration Tools is not listed in the Support Matrix, download and install the

Microsoft iSCSI Software Initiator using the following steps:

Dell Cluster Configuration Support Matrices at