Dell SCv2080 소유자 매뉴얼 - 페이지 41

{카테고리_이름} Dell SCv2080에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell SCv2080 49 페이지. Storage center
Dell SCv2080에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (24 페이지), 시작하기 매뉴얼 (23 페이지), 소유자 매뉴얼 (45 페이지)

페이지 인쇄

Figure 30. Replacing a Storage Controller

Storage controller

Locate the battery removed earlier and insert it into the replacement storage controller.

a. Align the battery with the slot on the storage controller.

b. Slide the battery into the storage controller until the release tab clicks into place.

Insert the replacement storage controller into the chassis until it is fully seated.

Reconnect all the cables to the storage controller.

Push the release lever toward the chassis until it clicks into place. The storage controller is powered

on.

NOTE: When a storage controller is powered on, a one‐minute delay occurs while the storage

controller prepares to boot. During this time, the only indication that the storage controller is

powered on are the LEDs on the storage controller. After the one‐minute delay, the fans and

LEDs turn on to indicate that the storage controller is starting up.

10. In the Dell Storage Client, make sure that the replacement storage controller is recognized and

shown as up and running.

NOTE: If the Storage Center software on the replacement storage controller is older than the

software on the existing storage controller, the storage system updates the replacement

storage controller with the software version on the existing storage controller. The Storage

Center software update on the replacement storage controller could take 15 to 45 minutes to

complete.

11. Clear the swap status for the temperature sensor and I/O module.

a. Click the Hardware tab.

b. In the Hardware tab navigation pane, expand the enclosure.

c. Select Temperature Sensors.

d. In the right pane, right-click the sensor, then click Request Swap Clear.

Replacing SCv2080 Storage System Components

Release level