Dell SD630-S 배포 매뉴얼 - 페이지 25

{카테고리_이름} Dell SD630-S에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell SD630-S 31 페이지. Designed for scality ring

Installing the OS

The operating system (OS) installation steps vary depending on the particular OS being installed. To install

your OS, see the OS vendor for instructions.

About this task

To install the OS, complete the following steps:

Steps

Attach monitor, keyboard, and mouse to the server.

•

You can configure all Dell SD630-S servers and each of the two Physical Servers within each Dell

SD7000-S server to enable a virtual console to launch the iDRAC8 web interface, which provides

remote access to the servers. (Optional)

•

(Optional) Log in to iDRAC8 from a remote system.

Initiate the OS install.

Configure the OS partitions.

Install required packages (yum update).

Configuring iDRAC8 for remote network access

(optional)

About this task

Use the following optional procedure to configure iDRAC8 network settings to enable remote access.

Steps

As the server restarts, when prompted, to enter System Setup, press the F2 key.

From the System Setup menu, click iDRAC Settings.

From the iDRAC Settings menu, click Network.

To the right of NIC selection, from the drop-down menu, select LOM1.

Scroll down the iDRAC settings menu and configure the IPV4 settings.

About this task

NOTE: The steps here describe the OS installation using a remote virtual console launched from the

iDRAC web interface. In addition, you can use a direct attached monitor to configure each server

and to directly start on a bootable USB device with an ISO file to install an OS.

Use the following procedure to launch a Virtual Console.