Dell Storage MD1400 series 소유자 매뉴얼 - 페이지 13

{카테고리_이름} Dell Storage MD1400 series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Storage MD1400 series 37 페이지. Storage enclosure
Dell Storage MD1400 series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (7 페이지), 관리자 매뉴얼 (48 페이지)

페이지 인쇄
Dell Storage MD1400 series 소유자 매뉴얼

Installing the front bezel

1.
Hook the right end of the bezel onto the chassis.
2.
Fit the free end of the bezel onto the system.
3.
Secure the bezel with the keylock.

Hard disk drives

Safety: Models AMT, E03J, and E04J

Models AMT, E03J, and E04J are intended for installation only in restricted access locations as defined in
cl 1.2.7.3 of IEC 60950-1:2005.
On the basis of your configuration, your enclosure either supports up to up to 12 3.5-inch SAS hard disk
drives in internal drive bays. Hard disk drives are connected to a backplane using hard disk drive carriers
and are configured as hot-swappable.
CAUTION: Do not turn off or reboot your enclosure while the hard disk drive is being formatted.
Doing so can cause a hard disk drive to fail.
When you format a hard disk drive, allow enough time for the formatting to complete. High-capacity
hard disk drives can take many hours to format.

Removing a hard disk drive blank

CAUTION: To maintain proper system cooling, make sure all empty hard disk drive bays have
blanks installed.
1.
If installed, remove the front bezel. See
2.
Press the release tab and pull the hard disk drive blank out until it is free of the hard disk drive bay.
Removing the front
bezel.
13