Dell Storage MD1400 series 소유자 매뉴얼 - 페이지 23

{카테고리_이름} Dell Storage MD1400 series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Storage MD1400 series 37 페이지. Storage enclosure
Dell Storage MD1400 series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (7 페이지), 관리자 매뉴얼 (48 페이지)

페이지 인쇄
Dell Storage MD1400 series 소유자 매뉴얼
Required Wires
•
One UL 4 AWG, 2 m maximum (stranded) black wire [–(48–60) V DC]
•
One UL 4 AWG, 2 m maximum (stranded) red wire (V DC return)
•
One UL 4 AWG, 2 m maximum (stranded) green/yellow/green with a yellow stripe wire (safety ground)
Assembling and connecting the safety ground wire
WARNING: For equipment using –(48–60) V DC power supplies, a qualified electrician must
perform all connections to DC power and to safety grounds. Do not attempt connecting to DC
power or installing grounds yourself. All electrical wiring must comply with applicable local or
national codes and practices. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow all safety instructions that came with the product.
NOTE: It is recommended that you use stranded copper wire type.
1.
Strip the insulation from the end of the green or yellow wire (safety ground wire), exposing
approximately 4.5 mm (0.175 inch) of copper wire.
2.
Using a hand-crimping tool, crimp the ring-tongue terminal to the green or yellow wire.
3.
Connect the safety ground wire to the grounding post on the back of the system using a #6/32 nut
equipped with a locking washer and tighten it firmly to the grounding post.
Figure 17. Assembling and connecting the safety ground wire
1.
#6/32 nut
2.
spring washer
3.
locking washer
4.
safety ground wire terminal
5.
grounding post
23