Dell DF10MXL 시작하기 매뉴얼 - 페이지 24
{카테고리_이름} Dell DF10MXL에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell DF10MXL 36 페이지. Networking mxl 10/ 40gbe switch io module
페이지 인쇄Configuring the Management Port IP Address
Assign IP addresses to the management ports in order to access the system
remotely.
1
Enter INTERFACE mode for the Management port by entering the interface
ManagementEthernet
2
Assign an IP address to the interface by entering the ip address
INTERFACE mode.
3 Enable the interface
mode.
Configuring the Default VLAN IP Address
Assign IP addresses to the default VLAN in order to access the system remotely.
1
Enter INTERFACE mode for the VLAN by entering the interface vlan 1 command
in CONFIGURATION mode.
2
Assign an IP address to the interface by entering the ip address
INTERFACE mode.
3 Enable the interface
mode.
Configuring the Management Route
Define a path from the MXL switch to the network from which you are
accessing the MXL remotely. Management routes are separate from IP routes
and are used to manage the MXL switch through the management port.
1
Configure a management route to the network from which you are accessing the
system by entering
CONFIGURATION mode.
For more information about how to perform the initial configuration using
the CLI, refer to the Dell Networking OS Configuration Guide for the Dell
Networking MXL 10/40GbE Switch IO Module.
24
Installing and Configuring the Switch
slot/port
command in CONFIGURATION mode.
by entering the no shutdown command in INTERFACE
by entering the no shutdown command in INTERFACE
management route
the
ip-address/mask
ip-address/mask
ip-address/mask gateway
in
in
command in