Dell EMC N2200-ON Series 설치 매뉴얼 - 페이지 8

{카테고리_이름} Dell EMC N2200-ON Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell EMC N2200-ON Series 10 페이지. Powerswitch; external power supply installation
Dell EMC N2200-ON Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (10 페이지)

페이지 인쇄

MPS-1S wall mount

Use the four wall-mount brackets to attach an external power supply (EPS) to the wall.

You need a drill and a pencil to complete this procedure. This procedure applies to one EPS.

1. Remove the wall-mount brackets, wall anchors, and screws from the shipping bag.

This procedure uses four wall mount anchors, four M5 screws (length 16 mm), and eight M4 screws (length 6.8 mm).

2. Screw two brackets to the left side of the EPS using the M4 screws (length 6.8 mm) for each bracket, as shown.

Torque the screws to 10 in-lbs.

3. Repeat to attach two brackets to the right side of the EPS, as shown.

4. Hold the EPS or wall-mount template to the wall and mark the screw-hole locations on the wall with the pencil.

Wall mount locations for MPS-1S are approximately 8.37 in x 6.76 in (212.60 mm x 171.85 mm) (L x W).

N-Series EPS installation