Dell EMC PowerSwitch N3000E-ON Series 펌웨어 업그레이드 방법 - 페이지 6

{카테고리_이름} Dell EMC PowerSwitch N3000E-ON Series에 대한 펌웨어 업그레이드 방법을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell EMC PowerSwitch N3000E-ON Series 21 페이지.

Upgrade Dell EMC Networking N3000E-ON Switches

The procedure given below to download firmware to an individual switch or a stack of switches.

Please do not interrupt switch operation during the downloading process as this may result in corruption of

flash memory. Do not power off a switch undergoing the upgrade process unless specifically directed to do so

by the instructions.

NOTE:

A TFTP server must be on the network and the switch software

must be accessible to the TFTP server before attempting to download

the switch software by TFTP.

An annotated download example is shown following this section.

1. Back up your configuration.

2. Upgrade using telnet or SSH require default enable authentication method or enable password in current

configuration. If not configured follow steps below to configure an enable password:

console#configure

console(config)#enable password <password>

console(config)#exit

console#copy running-config startup-config

3. Download the 6.5.3.36 firmware image (N3000Advv6.5.3.36.stk) or 6.5.3.6 firmware image

(N3000AdvLitev6.5.3.6.stk) to the standalone-switch or stack master.

NOTE:

Activate the image to use as the boot (active) image after the switch

resets. Images on the N3000E-ON switches are named active and backup.

4. Activate 6.5.3.36 (Advanced) or 6.5.3.6 (Advanced-Lite) firmware.

5. Reload the switch.

NOTE:

How to access serial console of the N3000E-ON switch?



Use a supplied "RJ45 Yost to DB9 serial cable" to access the serial console.



Connect the RJ45 end of the cable to the RJ45 serial console port and the DB9 connector to your PC.



Download and Install the terminal emulation software on your PC (for example, PuTTY) to access the

serial console with the correct settings (default setting 115200 baud, 8 data bits, no parity bit, 1 stop

bit, and no flow control).

Figure.1 N3048EP‐ON with 48 10/100/1000BASE‐T Ports (Front Panel)

RJ-45 serial console port

Page 2

O u t - o f - B a n d M a n a g e m e n t P o r t