Dell Force10 MXL Blade 시작하기 매뉴얼 - 페이지 26

{카테고리_이름} Dell Force10 MXL Blade에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 MXL Blade 38 페이지. 10/40gbe blade switches
Dell Force10 MXL Blade에 대해서도 마찬가지입니다: 애플리케이션 노트 (6 페이지), 사양 (2 페이지), 매뉴얼 (27 페이지)

Dell Force10 MXL Blade 시작하기 매뉴얼
Use only QSFP transceivers and QSFP cables (separately purchased) to
connect stacking ports as follows:
1 Insert a QSFP cable in the bottom stacking port on the rightmost switch.
2 Connect the upper stacking port on the next switch to the left.
3 Continue connecting each switch to the next in this way until you reach
the leftmost switch in the stack.
4 On the leftmost switch, connect the bottom stacking port to the upper
stacking port on the rightmost switch to create a loop.
NOTE:
The resulting ring topology allows the entire stack to function as a single
switch with resilient fail-over capabilities.
If you do not connect the leftmost switch to the rightmost switch (Step 4), the stack
operates in a daisy-chain topology with less resiliency. Any failure in a non-edge
stack unit causes a split stack.

Configuring and Bringing Up a Stack

NOTE:
Although stacking is supported on 40GbE ports on the base module or a
2-Port 40GbE QSFP+ module, this section shows how to configure stacking only on
the base-module ports (Figure 1-9).
To convert the 40GbE ports on the 2-Port QSFP+ module from their default 4x10GbE
mode of operation to 40GbE mode to configure a stack, refer to "FlexIOTM Plug-in
Modules" on page 7. After the converting the ports to 40GbE, you do not have to
reload the switch because a switch reload is required as part of the stack
configuration procedure.
After you attach the QSFP+ cables in a stack of MXL 10/40GbE Switches, to
configure and bring up the stack, follow these steps:
1 Connect the terminal to the console port on an MXL 10/40GbE Switch.
Enter the following commands to access the CLI and configure the two
40GbE ports on the base module for stacking mode:
Login: username
Password: *****
FTOS> enable
FTOS# configure
FTOS(conf)# stack-unit 0 stack-group 0
FTOS(conf)# stack-unit 0 stack-group 1
Where
stack-unit 0
configuration of a switch;
26
Assembling a Switch Stack
defines the default stack-unit number in the initial
stack-group 0
defines the stack group for the