Dell Force10 MXL Blade 매뉴얼 - 페이지 9
{카테고리_이름} Dell Force10 MXL Blade에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 MXL Blade 27 페이지. 10/40gbe blade switches
Dell Force10 MXL Blade에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (38 페이지), 애플리케이션 노트 (6 페이지), 사양 (2 페이지)
페이지 인쇄
Stacking Dell Force10 MXL 10/40G Switches
Port numbering
When installed in a PowerEdge™ M1000e Enclosure, the MXL 10/40GbE external switch ports are
numbered 33 to 56 from the bottom to the top of the switch (ports 1-32 are internal 10G ports):
• 40GbE base-module (built-in) ports:
In 2x40GbE mode of operation (default), the ports are numbered 33 and 37.
•
In 8x10GbE mode of operation, the ports are numbered 33 through 40.
The 40GbE mode of operation is required for stacking. For information about how to change
from 8x10GbE mode to 40GbE mode, refer to
40GbE QSFP+ port
• 2-Port 40-GbE QSFP+ expansion module operating in the default 8x10GbE mode:
•
In expansion slot 0, the ports are numbered 41 to 44 and 45 to 48.
•
In expansion slot 1, the ports are numbered 49 to 52 and 53 to 56.
The 40GbE mode of operation is required for stacking. For information about how to change
from 8x10GbE mode to 40GbE mode, refer to
40GbE QSFP+ port
• 2-Port 40-GbE QSFP+ expansion module operating in 40GbE mode:
•
In expansion slot 0, the ports are numbered 41 and 45.
•
In expansion slot 1, the ports are numbered 49 and 53.
• 4-Port 10-GbE SFP+ or 10GBASE-T module (NOT USED FOR STACKING):
•
In expansion slot 0, the ports are numbered 41 to 44.
•
In expansion slot 1, the ports are numbered 49 to 52.
Only one 10GBaseT expansion module can be installed per MXL.
See
Appendix B – Port mapping
below.
below.
Figure 3.
Port mapping for QSFP+ ports
for a complete list of port numbers.
Combining split 10GbE SFP+ ports into a single
Combining split 10GbE SFP+ ports into a single
7