Dell Force10 S4810 배포 매뉴얼 - 페이지 33

{카테고리_이름} Dell Force10 S4810에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S4810 36 페이지. Dell force10 s4810 switch
Dell Force10 S4810에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (27 페이지), 구성 매뉴얼 (17 페이지), 구성 매뉴얼 (17 페이지)

페이지 인쇄
Dell Force10 S4810 배포 매뉴얼
•
•
•
•
•
•
•
Related

openflow of-instance

Commands
openflow of-instance
Create an OpenFlow (OF) instance or modify an existing OpenFlow instance.

Z-Series, S4810

Syntax
openflow of-instance of-id
Parameters
of-id
If you are creating a new OF instance, enter the number you want to assign to the OF instance.
If you are modifying an existing OF instance, enter the number of the instance you want to
change.
NOTE: You must disable the OF instance before making any configuration changes.
Defaults
none
Command Modes
CONFIGURATION
Command History
Version 9.1(0.0)
Usage
•
Information
•
•
•
•
•
•
GVRP
IPv4
IPv6
MAC
MTU
Spanning-tree protocols
Switchport
Create or modify an OpenFlow instance.
Enter the number of the OF instance. Range is 1 to 8.
Introduced on Z9000 and S4810.
Stacking for S4810, controller High Availability, and VLT are not supported on OF
instances.
To enable OpenFlow on S4810, the stack unit number must be zero.
Up to eight OF instances can be created.
To establish a connection with the controller, you must enable the OF instance using
the no shutdown command.
To modify the OF instance, you must disable the OF instance first using the shutdown
command.
One controller IP and one TCP port can be configured for each OF instance.
The number of supported flows depends on the flow type. The following table provides
the number of supported flows for each flow type:
Flow Type
Maximum Number of Available Flows
ACL
256 or 512 (depending on ACL CAM carving)
33