Dell Force10 S4810P 빠른 시작 매뉴얼 - 페이지 10

{카테고리_이름} Dell Force10 S4810P에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S4810P 27 페이지. Quick start guide

Step

Task

Insert the optic into the port until it gently snaps into place.

Splitting QSFP Ports to SFP+ Ports

The S4810 supports splitting a single 40G QSFP port into four 10G SFP+ ports

using one of the supported breakout cables (refer to Installing the S4810 System

or Release Notes for the S4810 System for a list of supported cables).

You must enter the stack-unit portmode command for the system to recognize

the port type change. For example:

stack-unit stack-unit port number portmode quad

•

stack-unit: Enter the stack member unit identifier of the stack member to

reset. Range: 0-11

•

number: Enter the port number of the 40G port to be split. Range: 0-31

•

Splitting a 40G port into 4x10G port is supported only on a standalone unit.

•

Split ports cannot be used as stack-link to stack an S4810.

•

Split ports S4810 unit cannot be a part of any stacked system.

•

The unit number with the split ports must be the default (stack-unit 0). This

can be verified using the show system brief command. If the unit ID is

different than 0, then it must be renumbered to 0 before ports are split, by

entering in EXEC mode: stackunit id renumber 0

•

The quad port must be in a default configuration before it can be split into

4x10G ports. The 40G port is lost in the running-configuration when the port

is split, so be sure the port is also removed from other L2/L3 feature

configurations.

•

The system must be reloaded after issuing the CLI for the change to take

effect.

Supply Power and Power Up the System

Supply power to the S4810 after the chassis is mounted in a rack or cabinet.

Installing the Hardware

NOTE: Both rows of QSFP+ ports require that the 40G optics be

inserted with the tabs facing up.